Where is this machine located?
Type: Posts; User: slucas_clmach
Where is this machine located?
I generally program most of my cuts to the edge of the tool. But on occasion a center line program will be needed. The problem is usually one of clearance between part features or workholding when I...
The 4th disk is in deed a 'technology' disk. It contains the .tec files which are your E registers settings or E paks. If you have the books, you will most likely be able to get by without it.
Does anyone know of a chronological history of mazak machines and/or controls? With all the naming changes, it is difficult to keep track of which control came when?
Yes this appears to be the way it works on my machine.
Do you have a sample like this that I can look at?
I have a multiple fixture/part setup to do, right now I run one .iso program and then...
Ok thanks I might need to do that.
I always remove the file extension on programs to be loaded on my Milltronics machines.
Ok, after checking the power and setting the transformers. We have a machine powered up. Replaced the batteries. Now the system software stays put after cycling the power. Now if my manuals would...
Thanks for the tip on the batteries. I have them on order and a few other parts.
Shawn
I have used this procedure on my Robofil 200 and when I 'Continuer' the screen goes blank and all the keys but power off are unresponsive. I also have to load the system software after every power...
I am also having problems with this. How do I initialize this machine and what exactly does this do?
Shawn
Thanks Gary,
I checked on the web at the places you mentioned and only found the stops pictured. Any other ideas? I could build them as a shop project I guess, but that might be more expensive...
Come on guys, surely somebody knows where I can get these quill stops.
Hey guys,
I am looking for a source for the quill stop in the pictures attached. Anyone purchased these anywhere?
Shawn
I am trying to get a Centroid M400 to network with the rest of my network. After downloading the TB99 tech bulletin and following the instructions very carefully, I am still not able to send and...
I would most likely use a different ejection technique. Ejector pin marks on a surface that you are going to put against your mouth would be questionable. I have built this type of tool with an...
CL Machine, LLC
430 S High, Unit C
Joplin, MO 64801
ph/fax: 417 659 8765
cell: 417 438 9437
email: [email protected]
CNC Milling: 40 x 20
Tom,
you mentioned:
The R2040 will offer not only +-10 volt analog output, but also 0 to + 10 vdc output for controlling VFD's etc. While they do not work as nicely as a real servo drive, they...