Damm camera is crapping out so I can;t get a pic of the dataplate. It's a permanant magnet "treadmill duty 2.65hp 130vdc", "cont duty 1.5hp 90vdc. Neither p/n on it (G-190528 or N-1CPM 138T) comes...
Type: Posts; User: murph64
Damm camera is crapping out so I can;t get a pic of the dataplate. It's a permanant magnet "treadmill duty 2.65hp 130vdc", "cont duty 1.5hp 90vdc. Neither p/n on it (G-190528 or N-1CPM 138T) comes...
I know this circuit needs to go between the green and blue wires of connector H2 -
GREEN- This wire brings the speed sensor signal to the console. This is a pulsing 0, 5 VDC signal as the...
Will I get booted from here if I admit to this being used for <gasp> manual motor speed control?
Hope not :) Because that's where it'll end up, either on the lathe or drill press.
Andy
There are oodles of "how tos" on adding manual speed control to an MC-60 motor controller board. I'm trying to find something similar on the MC2100 -
...