thanks for the quick reply. Your private message inbox on CNC zone is full :P but me email is "bjarni at bmj . is"
Type: Posts; User: bmquist
thanks for the quick reply. Your private message inbox on CNC zone is full :P but me email is "bjarni at bmj . is"
Hi I have same fault on my screen (but it is not the cable) I have narrowed it down to the A16B-3200-0020 board, which is (As far as I understand) the main CPU/computer board, and after contacting a...
Hi
I was just rebuilding an old Swiss made CNC lathe, the brand is Schaublin. I added new controls to it. it is servo controlled and uses mach3.
to the point... I also have a CNC plasma machine...
OK thanks, for the clarifying, I will go for the 150 unit, I already sent e-mail to proma-elektronika a week ago and still have not received any reply, how did you order yours, did you send them...
I am also looking for a THC, I think I will get the Proma THC, atleast to beginn with, as my table maximum speed/feedrate is 3100mm/min and I never cut anything thinner than 2mm, or atleast in very...
My "problem" is that I have a 1,5x1,5 meter size plasma table and the edges on the table are standing 1-3 mm higher than the working area so if I am cutting larger plate that stands out of the...
I am pretty sure that the motors and encoder works, because I can tune it in DC tools and I can make the motor spin by checkmarking "invert encoder" (then it turns until too many errors because the...
Thanks for the reply Montabelli!! no I have not tested the motors in GD tools, but I can tune them using DCtools. How can I test them in GD tools? what is the easiest method? is it possible to make...
how ever I can tune both axis using DCtools and if I checkmark the "invert encoder" then the motor spins in the wrong direction, but when getting commands from mach3 it does not move, only axis 1...
Hi Xerxes
I am helping a friend of mine to fix an old schaublin 102 cnc lathe he has. The lathe has got two brushed DC motors one for each axis, one motor is 43Volt 230Watts and the other is...