If you have not yet got it follow this link
http://jamet.com/Fanuc_Web_Manuals/CNCs_Current/63604EN.pdf
Yogesh
Type: Posts; User: yssvaff
If you have not yet got it follow this link
http://jamet.com/Fanuc_Web_Manuals/CNCs_Current/63604EN.pdf
Yogesh
I am based in India. I have a Robofil 200 and having the same problem. After loading the Communication disk the screen goes blank with this message E02 P01 ? at the bottom. Is this related to 24volts...
Christeon
I have a Robofil 200 and having the same problem. After loading the Communication disk the screen goes blank with this message E02 P01 ? at the bottom. Is this related to 24volts output....
Hello mdynac
The problem that I had mentioned went away when I changed the batteries. But now the machine has stopped functioning. The machine was showing the power supply error which I neglected....
Hi
I have recently purchaced a 1991 Robofil 200. I have not purchaced any software as yet and transfering programs thru serial port.
Problem is how to call sub programs from command files. I have...
Hi everybody
The machine has started. Did a small job, a square, in 3 cuts. But I don't have a wire tension meter so the tension could not be exactly adjusted. So the finish was not that good.
The...
Thanks
Followed ur instructions and the machine started. Wasted 3 to 4 hrs in front of a blank screen in the morning.
yssvaff
Thanks
Wasted 3 to 4 hrs in front of a blank screen.
yssvaff
When I started the robofil 200 this morning I pressed the monitor key. The machine displays the following " E05 P07? " All the keys on the cabinet are not functioning. I switched of the machine but...
I am very new to edm and cnc programming. Esprit software maybe quite costly as I a beginner. What is the cost of Esprit I didnt get it on their website.
Thanks for the reply. The machine is still not powered on. Will take a weeks time to power it on.
Thanks yssvaff
hi
I am new to wire edm and also to cnc software. So please help.
I wanted to know which software you all are using to operate the Robofil 200.
Dolpin EDM software has Robofil 200 post processor....
hi
I am new to wire edm and also to cnc software. So please help.
I wanted to know which software you all are using to operate the Robofil 200.
Dolpin EDM software has Robofil 200 post processor....
Hi
I have just purchaced Robofil 200 wire edm. Not started it yet.
How did u solve the problem of E666 error.
yssvaff.
Hi
Just purchaced 1991 make Charmilles Robofil 200 wire edm. Have not powered it on. My question is : what controller is used in this machine. What maybe the speed of cutting for say 10mm steel...