So I have a Mitsubishi M-TC8B lathe. You would think calling MEAU would get you to someone who can actually help with the actual machine but its hit/miss. I have talked to techs who say yes we have...
Type: Posts; User: Seven30
So I have a Mitsubishi M-TC8B lathe. You would think calling MEAU would get you to someone who can actually help with the actual machine but its hit/miss. I have talked to techs who say yes we have...
I would be immensely grateful if someone would be able to sell me a good parameter set for a 94 Mitsubishi M-TC8B.
I just bought a good looking M-TC8B/325lg-v and the M161-1 DIED LESS THAN EIGHT...
Just an update for any poor soul in the future.
The mc161 card was in fact faulty.
I found a matching card number and transferred over the match chip and the eprom (JIC).
Now for complete...
Based on the Z54 DIO 5V DOWN 0003 I swapped out the 724-1 graphic card and now have a blue screen.
Tried the 1-3 1-3-5 reset but no green lights on MC 161. For grins pulled out the two MC301 cards...
Is my 161B faulty? this is a 325LGV on mitsu lathe.
It did a hard stop. A reboot came up with these errors>
Z56 FIX_P
Z54 DIO 5V DOWN 0003
Z70 ABS
Y02 SYSTEM ALARM 0060 79F6
Subsequent...
>>> ITS DEAD JIM <<<
I have this new to me Mitsu TC8B with a 325LG-V powered up less than 24 hours and it DIED!
I was making my first backup and reading over the procedure when the control did ...
Hi Alan, this is a pretty crusty thread but wondering if you still around and if so could share your clarified parameter upload procedure. Im looking at a Mitsubishi MT8 and just prepping for...
Anyone know much about the MITSUBISHI M-TC8B turning centers?
It running the Meldas 300v control but I dont find much about the iron
good or bad. Which may be bad....
This must be a rare machine which is a bit scary. Anyone run one?
I am starting the hunt for a two axis lathe. Curious if anyone has experience with the Mitsubishi M_TC8b.
Im not finding a lot of info on its merits or lack of.
That is good to know! Is there anything in particular to watch for on the HT 20J?
Hi John,
I was looking at a nice condition Hitachi Seiki HT20J with Seicos J Multi.
Not sure what control its based on but does your team still have parts/support for this
"classic" ?
Im surprised you got no responses. Your mill probably has the 10k spindle. There is an air-oil mister that supplys air to the spindle. About 10cfm !!!
There should be a solenoid to shut it off a...