Thanx for the reply. I have no idea why you are blocked or how to undo it, but I’ll look in to it. I haven’t run a job yet (Mother’s Day), but I put the old driver back in(sending the 203v back to...
Type: Posts; User: Moretzmando
Thanx for the reply. I have no idea why you are blocked or how to undo it, but I’ll look in to it. I haven’t run a job yet (Mother’s Day), but I put the old driver back in(sending the 203v back to...
Yes, only on the x axis. I plugged my DM860A back in and everything is working. I tried every possible combination of motor and drives but the G203v just doesn’t seem to be communicating with my...
Yes. Swapped motor cables first, then drives. There is holding torque on the motor, just no motion. Thanx
Maybe I'm finally in the right forum
I posted a while back that I was randomly losing steps in the x direction during complicated tool paths when I speed up from 60 imp to 90 ipm. I hear how slow...
Thanx so much for the quick reply! Seems to be just holding
I posted a while back that I was randomly losing steps in the x direction during complicated tool paths when I speed up from 60 imp to 90 ipm. I hear how slow that is all the time, however I’ve only...
I posted a while back that I was randomly losing steps in the x direction during complicated tool paths when I speed up from 60 imp to 90 ipm. I hear how slow that is all the time, however I’ve only...
I’m just getting started actually cutting parts. I’ve done several Turkey pot calls for a friend. I started out at 60 ipm with the roughing. Then I switched to 90 ipm and trimmed my time down from 22...
That is too funny, right after posting this I was looking at my new 1/4” upcut bit, making sure I didn’t by downcut, bumped my spindle on Viola! spindle is turning backwards! Thanx so much! I’ll...
First a background on my machine. I bought a used 6040 machine and trashed the electronics. I have individual Gecko drives, 60v power supplies, new bearings throughout, nema 24 455oz motors,...