Search:

I have vector drive capable drive, but I have newer managed to setup so that it would not go "over current".

I have only managed to run these spindle motors in v/f mode.
If i run normal 3-phase...

Hello

Currently I am running a fanuc asynchronous spindle motor with VFD in v/f mode.

It is rated to 200V at 17A 1500/8000rpm.

It's been running fine, I have used 17A at 100% spindle load...

Hello

First heres my mill project:
https://picasaweb.google.com/JSSKangas/CNC

My consern is can PM servo motor handle shock coming from spindle?

Will magnet hold in rotor, or not?

hmmm.. really interesting, if you use normal incremental encoder and emc2 directly drives 3 half bridges. You need to calcuate mathematical model of commutation. Does "Andy's bldc code" does this and...

Hello

Fanuc motor push out SSI info, absolute measurement, it is a high speed serial interface. It does not give out A B Z pulses.
Do you have what kind of servo drives to control these?
If you...

Hello

About bit basics.
First load geometry you want to mill.
Then go to manufacture side and choose machine.
Then go back to design state
move / rotate part in right position.
Go back to...

Hello

Thanks for reply. Problem solved.
I connected X.axis-cmd to pid.3 input.
Then I disconnect encoder feedback to joint 3 feedback.
This was because it always cave me a joint 3 following...

Hello

I'm implementing EMC2 to machine that have two servos in X-axis.
I'm using EMC2 live cd ubuntu 8.04 and MESA 5I20 fbga card.

I managed to create new PID-loop for 4th and 5th axis, but...

Try this

http://oeiweb.omron.com/Software/SoftReg/en/software-login.asp

Hello

I have same problem......

5 min later....

http://www.cx-programmer.com/read.php?tid=98
Try this link

http://oeiweb.omron.com/Software/SoftReg/en/software-login.asp