Search:

Dear Sir
I hope you can help us with a copy of Parameter and Diagnostic of Miyano BNC-34T with Fanuc OT control and B Axis, 2 turrets.
my email is [email protected]
Thanks in advance

Diego C

Hello Tornero32, I hope you can help us with a copy of Parameter and Diagnostic of Miyano BNC-34T with Fanuc OT control and B Axis, 2 turrets.
my email is [email protected]
Thanks in advance
...

Hello Ahmed:

I have a macgine like yours. but I do not have the manual with the parameters. Can you send me the parameters?

Thanks in advance

Diego Camacho

You are right, theres no alarms and all the servos are ready. At this point I exchange all the drives and boards (all CPU) with others machines that works fine. (same model, same control)

The...

The machine has no pallet or C axis. There is another condition that could inhibit just the movement of the X and Y, beacuse I can move just the Z axis.

Thanks in advance!

Steps to establish a communication between Okuma OSP5020L with PC

1. Verify the Optional Parameter Bit
NC OPTIONAL PARAMETER BITS

LATHE 7 6 5 4 3 2 1 0

1 0 0 0 1 1 0 1 1...

The Okuma small machine Lubrication works in an indirect manner. When the pressure reach the 180 PSI over all the system, the lubricator start to compress a spring and all the points, from the first...

Hello:

Where are you? There is procedure to check the power transistors and brige, but sometimes the control board is defective too. Send me an e-mail to me to talk about the way to send you...

Hello:

I want to know if anybody has experience on Hitachi Seiki with Fanuc 11M. After a electric variation problems in the floor, I can just sent to Home the Z axe, but I can not send to Home...

I need help to find all the parameters and PMC data for a Hitachi Seiki Mill with 11M Fanuc.

Thanks in advence

Diego

You need take off the cylinder of the collet.
Then start running the spindle at 50 RPM during 5 min, to make sure the grease are on all the bearing. After that you will need increase the RPM by 500...

Hello:

I have the programing manual for your lathe. Post me to know the details.