Thank you for your reply, you have answered most of my questions.
I was not so much aspiring to have Megabytes available, just curious about how Fanuc used the memory. 64k seemed like so little to...
Type: Posts; User: WarpCore
Thank you for your reply, you have answered most of my questions.
I was not so much aspiring to have Megabytes available, just curious about how Fanuc used the memory. 64k seemed like so little to...
According to the original build sheet for my control I have 4Mb of program memory and 4Mb of main memory. The System Configuration page also shows two 4Mb boards present (see pics), and I happen to...
Thanks for the replies and the info.
I have checked that the settings are the same at the machine and the PC, and also tried different baud rates and other settings.
Settings that I usually run are...
Hi all,
I have an 18MC with the following IO problems:
IO ports 0 & 1 (JD5A) will receive files from the PC no problem but will not upload to the PC. The PC times out and on the machine 'Output'...
Thank you, very much appreciated.
Oh darn, that's disappointing. Well thank you for trying. If it's not too much bother may I try again with a different email?
Hi all,
I am just wondering if anybody can direct me to information regarding the communication protocol between Dataserver and CNC boards, and the pinout of the backplane connectors.
To clarify,...
Thank you for the reply, I have sent you an email.
I know its been 12 years since this post, but if you are still out there and still have this info, any chance you could send me a copy? [email protected]
Cheers
K
Thank you for the reply. I did not know I could boot up without the dataserver board. That is very helpful and will narrow down the areas that could be causing the problem.
Cheers
Hi all,
As per title I have an 18-MC controller on a VMC.
The machine is shutting down with error - '972 NMI occurred in other module, slot 13'
I suspect the error is emanating from the...