584,802 active members*
4,742 visitors online*
Register for free
Login

Search:

Type: Posts; User: Hydralift

Search: Search took 0.00 seconds.

  1. CAM with post processor for LVD laser with Fanuc 16LB control

    Hi,

    Any suggestion for a simple CAM program that has post processor for LVD Impuls laser with fanuc 16Lb control?
    I just need a simple post processing software I do not need nesting. I have all...
  2. Replies
    0
    Views
    1,584

    Stroke limit setup

    Hello everybody,
    I have an LVD Impuls 4030 equipped with fanuc 16LB conttrol. I have just installed and I have a problem with the stroke limit of Z axis. The table is lower than it was in original...
  3. Replies
    1
    Views
    578

    Re: Fraud CNC repair company

    I must revise my fist opinion because after all this story the French company accepted to complete the repair job on my control and they will take it back without any cost for me. They told me that...
  4. Replies
    2
    Views
    1,865

    Re: TNC 155 RS 232 parameters

    I tried already all the mentioned solutions, zero results now it has new problem. When I connect the cable the TNC server software freeze and writes that is receiving data but this is not truth. when...
  5. Replies
    1
    Views
    578

    Fraud CNC repair company

    Hello to everybody,

    I want to make a report so to worn anyone who will read it. I had a problem with TNC 155 Q control. I searched in internet to find who can repair it or who can sell me a used...
  6. Replies
    2
    Views
    1,865

    TNC 155 RS 232 parameters

    Hi,
    I have a TNC 155 which I have just repaired it and now I have to put the parameters. I have all the parameters except these that configure the RS232 port.
    I use TNCserver for transferring the...
  7. Re: Strange Problem with Mitsubishi Meldas 500

    Thanks but I'm in Bulgaria and I suppose that this network cannot give me solution for local service... or it can?
  8. Strange Problem with Mitsubishi Meldas 500

    Hi, I have a milling machine equipped with Mitsubishi Meldas 500 and I have a very strange problem. The machine starts properly without any error. All axes are working without error and I can move...
Results 1 to 8 of 8