Search:

Spiker604
Just read an old post by you about a Hardinge Conquest 42, I have a problem and can't figure out h to solve, had a tech come in and he wasted three days with no luck. I do have the...

Spiker604
Just read an old post by you about a Hardinge Conquest 42, I have a problem and can't figure out h to solve, had a tech come in and he wasted three days with no luck. I do have the...

Hi, thanks for the reply. Its a Conquest 42, Serial Number CS664, !988 vintage, OT Fanuc Control.
The Spindle will run fine in Manual or Set up but when I try to run a program it stops at the...

Don't Know, But I'll try tomorrow. Thanks.
Phil

HI
Have a Hardinge Conquest Lathe with a Fanuc OT Control, Hardinge won't give me the PLC for the machine (Said I have to get a service call) The Spindle runs fine in Setup or Manual Mode, but when...

I have a Yang Lathe with a Meldas 50L control. Is there a way to program for automatic operation with a bar stock puller. Can't figure out how to stop spindle, open chuck, infeed bar stock puller,...

I am making a fixture to make special collets (16C) on my Hardinge Conquest 42 CNC Lathe and need the Dimensions for the spindle mount, A2-5. The holes are easy enough to indicate, but the taper is...

Power Down Machine. Power Back Up, Put in Jog Mode, Move the Z axis 1" Minus, Move X axis 1" Minus, Press X axis Home, Then Z axis Home. The tailstock Will Only Move If TRAV button is pushed with the...