Don't know if you have got this sorted since, but would highly recommend you get in touch with DNC Electronics near Swindon. Their tech people should be able to help you diagnose whats going on with...
Type: Posts; User: ::Andy::
Don't know if you have got this sorted since, but would highly recommend you get in touch with DNC Electronics near Swindon. Their tech people should be able to help you diagnose whats going on with...
Where are you based?
I run two of these daily in the UK. They're very good production machines, both of mine are barfeed and like churning out parts as long as you keep an eye on the swarf build...
Hi All,
Thanks mbservice for your reply, it turned out we had indeed entered the wrong parameters. We have two GT which are similar in build date, but entirely different in build. The one which...
Hello all,
Trying to sort out a 1994 Build Hardinge GT which has had to have a Reset + Delete on start up after having a 911 alarm 'Ram Parity : (4N+1)' - The reset + delete got me a completely...
Hi Aaron,
Basically that document should be followed as you do the top 5 points in that order, when you come to point 4, you then have to either enter a 'D' bit (in which case follow the second...
Copy of the reinstate process for enabling the collect to work on a Hardinge machine again after complete loss of parameters and settings (Holding down Reset + Delete on start up)
Hope this...
Hello all,
I've been fortunate enough to receive the Hardinge Technical data on how to perform this operation. Will type it up tonight and hopefully make this thread worth while to someone in the...
Hi all,
Came in on Monday after a weekend out of the shop, fired up the Hardinge Conquest GT and was greeted with a '911 RAM Parity Alarm (4n+1)'
Tech guy on the phone said there was no way...
Hi All,
I'm in need of some help in the shape of a generic parameter setup for a Hardinge C42 circa 90's build.
I've had an issue where a 914 Alarm has appeared and tried the first thing in the...
Case closed :cheers:
Out of interest, anyone know why you can't get this machine in the UK?
Andy
Cheers Gary, I went to the training centre over here in the UK and got there with plenty of time so I had a chance to ask several question and that.
The Haas engineer/trainer basically said that...
Finally got around to getting the program i was running off the machine.
The G71 code i used was
G71 P90 Q190 U0.5 W0.1 D.75 F.2
N90 G0 X-0.5
G01 ZO. F.2
G01 X9.5 R-1.5
Z-7.5
X13.5 R-1.
Thats brilliant! Thank you!
OK, will do when i get a chance. ATM its being used as a seconded op machine and hasn't yet been used. I'm technically a miller and run a Haas Mini Mill. This is the first steps i've taken into...
Just got a TL1 last week and i noticed the same issues. Even when i got the guy who runs a Mori over to see if he could figure it out he couldn't. I was using standard G71 code not the...
We had an issue with one of our haas mills when it was cutting. Was on a 50% load cut and it just stopped, and a Z axis drive alarm came up and smoke came out of the top via the fan.
Turned the...
Brilliant! Thats all i can say!
Andy
Heya, I'm new here, but I run a Haas Mini Mill at work.
Just wondering about the last shot which show the machine up against a wall. How does the door open when its that close to a wall?
Andy