Search:

Ok i was told to get motor a06b-1003-b100

and

control a06b-6044-h007




does any one know the difference of the a06b 6044 h008 control?

ok i had my brother take the control to the place i found online to have it tested since i have a day job too. The place was in a bad neighborhood and was a house, i woulndt mind if i had been told...

My current boss has a megger at his.rock crushing company which.i.am trying.to get ahold of could take a few weeks, ill keep you guys posted, i have the spindle control out amd am trying to get it...

It seemed to run really smoth, And I will check A H J and K to ground, I think I already did and had no opens. But ill double check, also I pulled the spindle drive and will have it tested tomorrow.

Ok with the battery test the motor turn at about 100rpm, does that sound right

i will test that tomorrow.

also please way in on my options at this point.

1. I am almost at a dead point here, i try to work thru it but it could take awhile and all my free time.

2. pony...

It will not run at low speeds

And do I hook A to positive car battery and H to ground. And J to + and k to -,
also thank you for taking the time to write me.

i clean had pulled the motor off in hopes on taking it to a local motor re builder and having it tested i have not found a close one yet.

while it was off

-i cleaned the brushes and brush...

neliw20 i will try to do what you said but by the sounds of it i will more then likly have to call the tech in.


al the man, i can pull it part and clean everything, i can see how much the motor...

how do i measure that across the windings? i know alot of questions. sorry i just dont want to do it wrong and rule something out if im not sure.


also a tech told me field side of j to k should...

how do i test inductance?

i have no idea why but in the back of my mind i just felt like the motor was bad.

how do i test the fanuc model 3 d.c. motor.

thank you everyone i have been trying to figure this out for...

ok so if that is low what does that mean?

where do j & k go to? the spindle motor? what do they do. are they the power wires?

ok with j&k disconnected from the board. and measuring the board side i get

78 volt D.C.

and on the wire side 0v d.c. and 3.4 ohms

also when do i check the voltage just when the machine is on?

or try to turn the spindle on and then check it with it alarmed out?


and when yu say across j and k feild do you mean on screw...

and i was hoping you would chim in al the man

i believe the resistance was 244 ohms not k just 244.

Volts between j and k is 8.9v dc

i will get that voltage and get back to you. Thank you i am really stuck on this and dont have the money to commit to $100 an hour plus drive time for a tech to come out. and spend a few hours then...

i have a kitamura S-12 and yesterday i went to start the spindle and it turned a few degrees then instantly throw a alarm. no alarm on the screen but on the spindle drive board l.e.d. #2 was on...

what machine, and what controller?

Have your tried the code? their are a few blanks for tool number and height offset change these your desired tool number and H offset and it should run, also remove the double spacing. and at the...