584,874 active members*
5,137 visitors online*
Register for free
Login

Search:

Type: Posts; User: Lotaxi

Search: Search took 0.00 seconds.

  1. Re: CAMWorks producing gouged parts with 3D toolpath

    Issue is that CAMWorks is a weird program with some things. Changing the machining direction 5 degrees solved it.
  2. CAMWorks producing gouged parts with 3D toolpath

    Hello all,

    I've been using CAMWorks for a couple years now, and while it works well ~95% of the time, occasionally I'll run into something that stops me dead for a while until I can figure it out....
  3. CAMWorks producing gouged parts with 3D toolpath

    Hello all,

    I've been using CAMWorks for a couple years now, and while it works well ~95% of the time, occasionally I'll run into something that stops me dead for a while until I can figure it out....
  4. Replies
    2
    Views
    1,650

    Re: Robofil 510 not rethreading during program

    SOLVED


    Issue was mechanical, not software based. The rethreading block motor had seized. we got it loose and it's working fine now.
  5. Replies
    2
    Views
    1,650

    Robofil 510 not rethreading during program

    Hello,

    I'm working with a Robofil 510 and I can't get it to rethread when the wire breaks during machining. It ONLY fails during rethread in the middle of a program, though. It will thread at the...
  6. Replies
    2
    Views
    2,061

    Charmille Robofil 510 Updated Files

    Hello all,

    I work for a tiny medical product development company and we recently started up a Robofil 510 machine. A lot of work went into getting it into good working condition, and now we are...
Results 1 to 6 of 6