I do a lot of consulting work for various automation projects. I have accumulated lots of CNC goodies that were good to have on hand for projects but I am no longer needing to keep this much...
Type: Posts; User: Vulcan R&D
I do a lot of consulting work for various automation projects. I have accumulated lots of CNC goodies that were good to have on hand for projects but I am no longer needing to keep this much...
I found more info it is an RDLC220-B from Ruida. I did find that I could change the 'steps' on the stepper driver itself so that I can get the X and Y axis to actually draw a square instead of a...
I recently purchased a laser from GWeike and it has been fine. The controller has stopped working. I had a backup controller that was ordered at the same time that is identical but the firmware...
I just wanted to give you guys a heads up in case you needed a tube. This seller has RECI tubes and the standard looking chinese tubes with $1 no reserve on them so they may go cheap and he ships...
I have been cutting MDF and melamine faced MDF (6mm) for some time on my chinese laser. I have never had a problem cutting the single sided melamine faced or the double sided melamine faced. ...
I am having problems with the coolant pump on our Mori MV50.
If I pull the pump out of the reservoir it spins, quietly for as long as I leave it on.
If I put it back into the reservoir it will...
Open Source Universal 3D Printer Extruder | DUAL EXTRUSION | by Chelsea Thompson — Kickstarter
Basically a Makerbot clone at a fantastic price!
I need a inserted threading bar for to make a 3/4-8 4 start acme thread on an ID. Any suggestions. I just found out the Sandvik tool I was looking at would be fine for 3/4-8 but not a 3/4-8 4...
I had a leak in one of the hydraulic lines right above the reservoir. I had lost approximately 1/2 of the hydraulic fluid and now the z-axis will not home and I cannot do a tool change but I can...
I was looking at the lubricated COF of various metals and it looks like to me that for a plain bearing, 304SS on 12L14 (or vice versa) once lubricated is one of the lower COFs. Due to the limited...
Does anyone have the procedure to align the turret in X? It is off by enough to where I can't drill any parts without snapping the tooling.
Any help would be appreciated. Thank you.
Actually it would be very similar to rifling except that it would need to be a sharp thread like a screw.
The length of the ID would only be 1" long, just one thread spiral preferably, in 303 or...
I need to create a VERY coarse thread pitch thread in a 1/16" ID. If I could get 1 thread per inch (for example) that would be great. Think of it as an ID version of an auger. Is there any way to...
We made these miniatures cannons on a Mori mill and a Haas lathe.
They have stainless steel barrels and anodized 6061 aluminum bases, with stainless or brass hardware. They pack quite a punch!
...
I just moved the shop and gotten the machines re hooked up to electrical and the only one having an issue is the Mori MV50.
The #10,9 and 7 LEDs are lit on the error panel in the CNC closet.
...