Hi, Mandis
I'm not sure I will check tomorrow morning and post back asap. The issue has been fixed but the supplier has no idea why it happens it still does it from Time to time. They only fix it...
Type: Posts; User: X07gavrp
Hi, Mandis
I'm not sure I will check tomorrow morning and post back asap. The issue has been fixed but the supplier has no idea why it happens it still does it from Time to time. They only fix it...
Hi, Guys
Sorry if I've posted in the wrong area (noob), would greatly appreciate some help.
My syntec controlled cnc has just popped up with a error to do with my controller software.
When...
Yeah your probably right, I didnt seem to get much chipping with 100percent acrylic solid surface or Corian I know a 2flute 1/4inch is pretty much the cutter to use, but with modified solid surface...
Also set rpm to 14000 and feed rate to 12m pm
Sent from my Le X820 using Tapatalk
I cut a lot of modified solid surface I had great success with 8mm down shear cutter for rebates and 1/4inch 2wing comp cutter
Sent from my Le X820 using Tapatalk
Just a word of caution when buying Chinese machines if your company has to rely on it for everyday use STAY AWAY there only good for hobby or people who have general knowledge of machines
Sent...
Try cncnc.cc I've bought a cheap zk1325 cnc from them 3years ago, not bad for $8000aus delivered, it's been modified a lot since I bought it (now has 40w co2 laser installed on it) but never...
Mach only does this when in demo mode or licence key has been lost
Sent from my Le X820 using Tapatalk
Set steps per unit is what you need to set steps correctly for a axis to turn the degrees you wanthttps://uploads.tapatalk-cdn.com/20170608/3e8692367dc2c19b93071846957f344a.jpg
Sent from my Le...
Maybe I'm misunderstanding what your after, but to turn 1degree your steps need to be set correctly there is a setting in mach3 in settings witch will automatically work out the correct steps, once...
Also when I use 4th axis I turn on continous rotation to speed up the progress but depends what your Machining also centre of your rotary should be the 0point for z axis
Sent from my Le X820 using...
I use a lot of 4th axis rotary work on mach3 and to be honest all software I've used the best is desk proto 6 it is specially designed for 4th axis and all but really makes the job easy and it's not...
Good job great to hear you fixed it I'll keep it in mind in case happens to me
Sent from my Le X820 using Tapatalk
Louie is correct it's stalling mine would do exactly the same thing if velocity and acceleration where set wrong mach3 has a setting to configure this automatically also your step size setting on...
I have a syntec controlled cnc aswell I always have stupid problems with it one being because the Chinese cnc built machines are very simple and do not have proper limits set on, eg my tool carasoul...
If you can't even push it manually whilst it's switched off doesn't sound good
Sent from my Le X820 using Tapatalk
Try moving manually by hand back to home maybe it's triggered off a limit switch and reset machine
Sent from my Le X820 using Tapatalk
Sorry scrap cv bit just seen ur edit
Sent from my Le X820 using Tapatalk
Also make sure cv is on
Sent from my Le X820 using Tapatalk
I has same problem it was computer causing problem and also could be motion board but more then likely computer I had to reinstall mach and disable Antivirus sounds stupid but worked
Sent from my...
Sounds like maybe step over could be wrong with the cutter you are using, are u 3d engraving?
Sent from my Le X820 using Tapatalk