Hello
Can you please send manual on this mail id [email protected]?
I have one emag vl3 but I don't have manual So I can't operate properly and not make new program.
Type: Posts; User: vishal105
Hello
Can you please send manual on this mail id [email protected]?
I have one emag vl3 but I don't have manual So I can't operate properly and not make new program.
No it's not sorted can you please give me solution?
Hello guys,
I have Hitachi seiki hs500. In machine right now I can see only 3 axis (xyz) in controller. But 4th b axis module as well as motor also mounted in machine.
Can any one help me how to...
I lost parameter of Vigo servo
Can anyone help me?
Thank for reply rodney247
Where I can find optional parameter for yasnac i80?
Because I lost al parameters and I don't have any copy of parameters.
Yes I have.
Hello Srikrish,
did you get any success in this matter? Please replay me my mail id is [email protected]
Hi jignesh.
I am vishal from india please contact me on mail [email protected] I will provide you parameter of your machine If you didn't find still.
Thanking you.
Please refer this link to take back up from 16M controller
http://www.kfasllc.com/memory_backup_restore_F1618.htm
Mail me on [email protected] I need help for parameter.
Hi
How to change language in amada its520.20.
Hi please checek Z axis servo pack power cable and mccb.
333 FUSE (Z)
FUSE BLOWN Z.
WHEN OGN BI290 01 [S "I", FUSE BLOWN OR
MCCB TRIPPED IN Z-AXIS SERVOPACK.
If you still face issue pm me....
Yes check that also. How can you check igbt?. If igbt not short then issue in wiring please check that also.
Please check drive to motor wire. is it short or not?
If you still facing same issue then check igbt of drive module.
For any detail pm me or mail me on [email protected].
Dear Sir
I lost atc powermate f parameter.
Please help me.
Pm me I will teach full process of backup.
You didn't reply on what's app.
O9004 (cang/outils/m6)
3003=1
g0g28g91z0m9
g28g91y0.0
g49
m6
g90
3003=0
m99
Please try this macro.
O9004 (CANG/OUTILS/M6)
3003=1
G0G28G91Z0M9
G28G91Y0.0
G49
M6
G90
3003=0
I got issue in APC POSITION.
Use dnc to take backup from yasnac i80.
For more detail pm me.
Use NcLink software to take back up from fanuc controller.
[QUO
I have mori seiki sh-63 ladder file with parameter in pdf.
But atc controller power mate f paraeter and other file lost.
Can you send me a more detail about mori seki sh-63 on this mail id...
Can you explain more about your issue and machine detail?
Please whats app me I will send you macro program image. Just put it in your machine and run.whats app no. +91 8460945464
Please check below link hope you will find manual.
http://cncmanual.com/?s=Fanuc+spindle+manual+
Do you have manual? In manual all is there.
Can give me more detail about machine electric system like which controller used for machine and atc etc.
Please check tool arm proxy when tool clamp in arm sometes that proxy not sense so tool stuck in spinddle. I faced this issue many times then I checked so I got issue in proxy.
If you need image...
I have kitamura h500 with fanuc 11m of you want parameter of this machine please check attachment. More detail mail to me on this id [email protected].