Search:

It’s also interesting if the wave will be cased-harden.
Not that the surface layer will be gone and then its soft again.
Regards

Hello
You can contact Heidenhain directly – they should know it as they build these things.
greetings

Hello

I have not done something in the way, but I could imagine that the cutter simply needs to approach the part from the X-axis, and then run a particular value in Z and rotate the C-axis...

We have a Preciset 400 with the ImageController2 for 1 year now.
Its not bad – however you need to know where the device has its limits.
Its enough for us but if you want to measure µ, you better...

Usually you can decrease the rapid feed with the Poti or there is an extra button to have 25 50 or 100% rapid feed. We only have a SB and no PD so I can’t tell you it for sure.
In the parameter you...

Hello,
I did something simple.
I described the changing at a lathe from soft jaws to base jaws.
That was something, the examiners don't see everyday.

I emphasised the saftey and than after he...

Thanks
I’ll try that
Regards, Baconpep

Hello

Does anybody know the parameter for software end position at O-T?

We repaired the X-axis belt of our machine. Now the limit switch doesn’t fit and the hardware switch grips.

Greetings...

Hello

Does anybody have a spare programming guidance for Dialog 12? PDF format is preferred.
I have already tried to search but without success.

I also asked at Deckel but they want to have...

Hello

In our case activation of the milling mode is the requirement therefore. M60.
And then take G0 or switch to G98 before because usually it’s G99 (mm/rotation)

Regards, Baconpep

Can’t anybody tell anything?
A tip?

Regards, Baconpep

Hello

I have to turn a lot of bead parts.
The most of roughing work is from Dm 73 to Dm 32x 75lg.

I made a test, 150m with 0,354f and from 2mm
The plate got it (was already tightly worn out)...

Hmmm

Ok, so I have to live with it.
I haven’t worked with falling contour before.
But now we have a new programming system and there’re some little problems with it.
We have to change the PP a...

Hello

Write your program first

Baconpep

Hello

I have a question.
When I program a falling contour with G71 type2, then it riughes wonderfully, but doesn’t calculate G42.

The machine manufacture says it had worked before the machine...