I moved the Fuse as mentioned in the previous message. However, after a couple hours of actual operation, I now have a similar issue. I was in the rapid portion of a face mill operation moving at...
Type: Posts; User: Travis1581
I moved the Fuse as mentioned in the previous message. However, after a couple hours of actual operation, I now have a similar issue. I was in the rapid portion of a face mill operation moving at...
Yes, I now only have 1 20A fuse installed on the + side between the caps and the PSU.
I ran a loop of 100 of the following code:
G0 X7
G0 X0
No issues running full speed! I did slow down the acceleration slightly, but I think I will bump it back up and try again.
I just ordered some 20 amp fuses and will try this once they arrive (the 11th). Just out of curiosity, what wires are you twisting, power or signal? That setup is a lot cleaner than what I am...
So if I understand correctly, what you are suggesting is this with the fuse being 20 amps:
https://i.imgur.com/Qutif87.jpg?1
Please forgive me, but I don't understand how this changes...
I recently make the jump from steppers to servos on my taig mini mill. I run linuxcnc through mesa 5i25 & 7i76 cards. I had the system up and running for a total of 10 hours before I started...
It is a Taig 2018. You are correct, the lead screws are 1/2". So if I pick up this:
Deepgroove1 Gecko control box
I should get some of the speed I am looking for?
80/20 is not cheap. I believe each door on the original poster's enclosure is over $60... I haven't read through the entire thread, but I would guess that enclosure is in the $400-$700 ball park. ...
I purchased a used Taig mill about a year back. It was a manual mill that had been upgraded to CNC. I thought it was a great way to get into the machining world. That being said, my knowledge and...
I am sorry, but at this time I am not sending the part out for quote anymore. I have 5 different machine shops I need to get the information to.
You were not too late! I have yet to send out any information to anyone. Everyone wanted different file formats so it may take me a couple days to get around to everyone, but no one that has PMed...
I have received enough offers to quote the project. Please consider this thread dead. I will be in contact with all that have PMed me throughout the week.
Thank you for looking.
I am looking to have a few paintball bodies milled (4 or 5, the 5th depends on the costs). I have generated CAD models in solidworks and am ready to ship the blanks off.
What a blank looks like:...
Hello everyone! My name is Travis and I am a mechanical engineer located in Maryland. I am interested in getting a CNC milling machine. I have limited exposure with a 3 axis machine in high...