584,866 active members*
4,924 visitors online*
Register for free
Login

Search:

Type: Posts; User: tjwal

Search: Search took 0.00 seconds.

  1. Re: STATUS PROBLEM with 3018, woodpecker, Grbl controller,

    It is a console command like $$
    https://github.com/gnea/grbl/wiki/Grbl-v1.1-Commands
  2. Re: STATUS PROBLEM with 3018, woodpecker, Grbl controller,

    I think I had the same or similar problem. I could dump variables with $$, set x,y,z to 0. It would accept G commands but nothing would happen. Jogging would not change the position. I was tuning...
  3. Re: diagram of mitutoyo linear scale model AT112-one side is 9 pins?

    Did you ever figure this out?
  4. Replies
    814
    Views
    97,061

    Sid That is the same number I found on their...

    Sid
    That is the same number I found on their online store. They show about 650 in stock. Current price is $9.29

    JohnW
  5. Replies
    814
    Views
    97,061

    Steve It looks like I can get the older chip...

    Steve
    It looks like I can get the older chip from DigiKey. I'll just have to make up a large enought order to make it worth while ordering from them.

    Thanks

    JohnW
  6. Replies
    814
    Views
    97,061

    Pic18F452 discontinued

    One of my fav suppliers (HVWTech) shows that these chips are discontinued and are replaced by 18F4525.

    It appears to be a pin for pin replacement but there are some differences that seem to add a...
  7. Replies
    22
    Views
    3,543

    With a work envelope of 2x4x8 an X2 mill would be...

    With a work envelope of 2x4x8 an X2 mill would be big enough. They can be bought new for about $500. If you can find an RF30 or larger mill for a decent price, even better. There are a number of...
  8. Replies
    38
    Views
    6,663

    Hmm this must be the CNC group, what is really...

    Hmm this must be the CNC group, what is really needed is some old technology, think blacksmithing. Make up a mandrel that matches the hole. Heat up a gear blank in your forge and drive the mandrel...
  9. Replies
    20
    Views
    2,074

    It looks similar to this one...

    It looks similar to this one
    http://www.lathes.co.uk/blowerforge/
    It doesn't have the back gears which are used for very low speed cutting. It isn't that uncommon for those to be missing on a low...
  10. Replies
    20
    Views
    2,074

    It looks more like a metal turning lathe that has...

    It looks more like a metal turning lathe that has a wood lathe tool rest attached to it. I don't think I've ever seen a wood lathe with a prismatic way. the tailstock is also heavier than one would...
  11. Darcy Also check out SAIT in Calgary. One would...

    Darcy
    Also check out SAIT in Calgary. One would think that NAIT and SAIt would offer identical programs but apparently there are some differences.

    JohnW
  12. Replies
    887
    Views
    24,982

    Widgit Just finished reading all the posts. ...

    Widgit
    Just finished reading all the posts. Very impressive, especially the accuracy you are machining to. I'd be happy if I could consistently get 0.001"

    You really need to take up metal...
Results 1 to 12 of 12