Search:

Did you ever find any? I have some IDC 4001 drives that I think are the same as the ones you are looking for but rebranded. Step/direction etc.

-Huck

They are the AVS version sold by Bearing Engineers so im not sure.

Hello?

Al,

How does one measure inductance? Is there a way to do it with a normal (scope meter) multimeter?

Hello,

can anyone tell me how to measure the inductance of a servo? I have some PM brushless servos and they dont have any indication of the inductance on the case.

Thanks

Victor, (or Mike)

I have some odd Pacific Scientific motors that I want to use with my Teknic drives. You could say that I need to do a custom custom motor setup. I have some questions.

Is...

Hi,

So everything looks good for speed but can you tell me about phase stuff? RST and UVW? Are they the same just with different notation?
Thanks

Synchronism as in the rotor being synchronous with the rotating magnetic field? So I made myself a 3 phase bridge rectifier and measured the voltage and I was happy. However, as I dont know which...

Forgive me. Hold my hand. Speed in these motors is a function of voltage? Is this how the drive controls the speed of the motor? This is new ground for me. If speed is controlled by voltage,...

So, if a synchronous, permanent magnet, servo's speed is dependent on voltage, can I assume that the stated voltage for the motor is the voltage at top speed? If so, is there any reason that a drive...

Thanks for the advice guys. Mike, I didnt know you were on here. I'm Franklin Milton who contacted you about some of your servonut actuators that I got on ebay. Best deal ever, I got 8 THK...

You rock man, I have seen you all over the place on here giving good advice. Much appreciated. So, as its after 5 and I dont have any diodes handy, could I use a bridge rectifier and measure the...

Yes but? Will it work? Am I right about he speed in general? The odd fact is that they are custom and the only indication I could get about wich model they are is to cross reference the continuous...

Now, I understand that if I run my servos at a voltage that is less then recomended they will run slower. Is this bad for them? Is the speed decrese linear with voltage? I have some Pacific...

Victors,

I'm back. Can you describe what you mean about the serial ring in more detail? I dont see that phrase in the manual and am slightly (massively) inexperienced with servos and drives. ...

Victor,

I'm having some trouble getting the quikset software talking with my drives. Checked and rechecked the cable and it's fine. Port seems to be functioning. Any ideas? I tried three...

victors, cant I just tune one and then save a config file to the others? Also, what do you mean by 'make a ring?

Thanks