Search:

I had a CandCNC setup and it was a nightmare to use compared to PlasmaC.

With the RS485 control, in PlasmaC you set up a material list with given cut parameters for a certain type or thickness...

If your half handy and dont want to spend much money I suggest you look into building a new controller, reusing your motor drives and relays and such and controlling them with either a Mesa 7i76e or...

Have a look at this,

PlasmaC User Guide

It is a config for LinuxCNC and has support for internal THC using a cheap Mesa THCAD10. It can also be used with any breakout board as long as it had...

rodw,

That material that warped was 16mm thick. It roughly warped up about 40mm and yes PlasmaC's integrated torch height control handled it with out any drama. I have cut everything from 1.6mm...

I have been using the PlasmaC branch for about two months now running a production machine, All I can say is that PlasmaC is miles ahead of other linuxCNC plasma controllers,

I have had a lot of...

Thanks for that Mate,

The max speed I have had it run at was cutting 0.5mm black mild steel sheet at 4330mm/min, It did not have any problems at those speeds.

Before I had finished the guards...

More Pictures

Hi All,

This forum has helped me build my table so I thought I would share my pictures of the finished machine on here,