I think it's right the way, that you show on the pictures. We have one tm1 and tm2p
Regards
Enviado desde mi Moto G (5) mediante Tapatalk
Type: Posts; User: morens
I think it's right the way, that you show on the pictures. We have one tm1 and tm2p
Regards
Enviado desde mi Moto G (5) mediante Tapatalk
I already finish this job. The new drive it's working .
Enviado desde mi Moto G (5) mediante Tapatalk
Hello
Im working a Vertical Mill Haas VF1, a years ago i change on this machine a Magnetek drive for a AB VFD drive it works well until Now. It shows the Alarm 139 . I ll verify the wiring, and...
Hello
Could you solve the problem?
best regards
hello
i have seen one open once. it has 2 gears and onther small inside the gearbox that drive the shaft that moves the encoder.
millwright79
did you test manually the valve? and see in the diagnostics page that the value for this item its changing form 1 to 0 or viceversa.
you could try to open more the orifice of the...
Hello to all
i have a problem with a VF-0 machine,but this one doesnt have a delta - wye contactors, it is wired in wye mode trough the vfd to the motor.
i have an issue the motor has a jerk...
Hello
i try to repair the boards of a haas servo amplifier and a vector drive
1)65-4015H
Board Sub Assembly 32-4015H
2)69-1000
Vector drive
hello
i have a similar problem in a Vf4 and a Vf2 machines. the solution for me was change the quickexaust valve of the TRP. becouse like you check the change of the bits in the diagnostic...