584,841 active members*
4,388 visitors online*
Register for free
Login

Search:

Type: Posts; User: JKL79

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    15,155

    Help me identify this holder.

    Hello,

    After several hours of fruitless searching on Google I admit defeat and throw out the question to the expertise here. :o

    I got this Fanuc Model F Taper drill. It has an ATC with 7 slots....
  2. Re: Help! Problems with spindle/spindle driver on an old VMC100.

    Hi Dan!

    This is quite interesting news. I've thought about wiring up newer hardware to the existing controller before, but quickly dropped the thought due to it's complexity. But as you say it's...
  3. Re: Help! Problems with spindle/spindle driver on an old VMC100.

    Hi Dan!

    Sorry for late reply, been busy working...

    I hope the spiders you've acquired is in good condition. Let me know otherwise, and I'll send you one or two. :)

    I'm not sure about...
  4. Re: Help! Problems with spindle/spindle driver on an old VMC100.

    Hi Dan!

    Called KTRs office in Oslo today. They had the spider in stock. One unit costs 26 Norwegian kroner, that's about $3 a piece. They had a purchase fee of approx. $25 if you ordered for less...
  5. Hi Dan! I removed the encoder on my machine...

    Hi Dan!

    I removed the encoder on my machine yesterday evening. The red insert were grinded into small pieces. Unfortunately I unmounted the encoder before I read your warnings about the top cover....
  6. Re: Help! Problems with spindle/spindle driver on an old VMC100.

    Hi Dan!

    Nice to see that you've made progress. :) I'll take a look at my machine when I get home. Have you found any part number for the insert? Is it listed in the manual? I hope this solves the...
  7. Re: Help! Problems with spindle/spindle driver on an old VMC100.

    Btw. Dan, my spindle behaves the same way. From time to time, perhaps for half a second, it seem to find it's way back, albeit not running smoothly, and spins a couple of revolutions before going...
  8. Re: Help! Problems with spindle/spindle driver on an old VMC100.

    Hi Dan!

    Thanks for you reply!

    I seldom use the M05 command, since I think the machine is a pain to program I usually just run it through the EXEC menu. But I can't remember ever being able to...
  9. Re: Help! Problems with spindle/spindle driver on an old VMC100.

    And here is the video..


    https://vimeo.com/124974349
  10. Help! Problems with spindle/spindle driver on an old VMC100.

    Hi!

    As the title says... Need advice here,,, My Emco just started acting crazy..


    Started it up 2 hours ago. It homed to reference point just fine. Changed tool fine, and the spindle ran fine...
  11. Replies
    8,430
    Views
    318,938

    Sticky: Re: Welcome thread-tell us about you.

    Hello,

    I'm about to start a retrofitting of an old Emco VMC100 with TM02-controller and I'm hoping to gain more knowledge about this by participating at this excellent forum. :)
    On daily basis I...
Results 1 to 11 of 11