If you are still looking for this Bond Plywood near Detroit has it
Type: Posts; User: UncleAugie
If you are still looking for this Bond Plywood near Detroit has it
Sorted it out this am, had a blockage. The machine sat idle for almost 8 years, it should have been expected. Thanks
Do you ever find the solution? i have a new to me 120 and am running into the same issue
I as I initially thought it was operator error. Solved
I am getting PLC Error 125 whenever I use attempt to call a 1/8inch end mill or 1/4 inch end mill in a program, I was able to use the V carve bits, but that is now causing an issue. Anyone have any...
As far as I can tell Im not, I actually copied the tool file of another record 120 user in finland. I am at a loss as to my next step. I have more than enough for the machine to do using the 3/8 and...
I cant seem to get the CNC to use anything smaller than 3/8ths. Larger works no problem, v carve bits work without issue as well. Whenever i try to run a program with a 1/4 inch or smaller bit I get...
Buy a $20 hand held pump or make your own for less. http://www.instructables.com/id/make-a-manual-vacuum-pump-for-under-$20-by-convert/
You have mentioned this file a few times, I do no find that information in my help file. It has very little in the way of information. any chance you could copy and email me the files? thanks
Baldo, do you still have your Record 120? I have just aquired a 120 and have little to no documentation. Hoping you might be able to help
I have a post processor for use with Fusion360, any work-a-round there?
Thanks, which machine do you have? BTW will be buying joint cam once im up and running for sure!
Hey everyone, I am working on getting a Record 120 up and running, I have zero documentation on the Xilog software. Does anyone have a user manual? at this point im just trying to get everything...
LIttle late as I have already been posting, but sit on back and ill tell you a tale, a tale of a CNC
Moved my one man woodshop into new digs fourth of July weekend 2016. Great Building, old...
No Xilog is a SCM product, they are supplying you with NUM software to control the router.
When I spoke with SCM they even stated they dont use the XiLog software, they recommend using MMI_NUM
NUM told me they have a PC replacement for our FT40 units for about $2k USD including modern software
dmitry83, do you have a record 120? We should start a knowledge base for the older SCM...
SO Im 99% of the way there, and Im hung up on this one step. Need the Servo Drive parameters, anyone?
basides contacting italy any ideas?
I have the software on my machine, but not the manuals, do you have a copy you can link me to? I am running Xilog3 on a Record 120 built in 2000
Have you had any success? I just picked up a Record 120 as well. Sorting out the bugs now. I am looking for a manual for the Xilog software, any suggestions?
Sorted out that error, had a loose fitting.
Do you have a working post for Autodest Fusion 360 and a SCM Record 120?
Thanks
Thanks for that, I really appreciate the advise. I will be looking for an aftermarket solution.
My next question is running down Errors. The Machine I have acquired has sat for a while and didn't...
Aquired an older Record 120 that has been no use is a few years. Going through error codes one at a time. Starting with this one.
Any recommendations? Better yes is there an online copy of the...
DO you know if there is a SCM post that will work for Autodesk Fusion360?
I have picked up a 1999 vintage SCM Record 120. I run a small woodshop and will be using the machine for panel work, but...