Jim thanks for the quick reply. Strange you mention that. Bob from Hypertherm suggested that as well. Do you have personal experience with this problem? I did turn on the air through the hose...
Type: Posts; User: mchuhn
Jim thanks for the quick reply. Strange you mention that. Bob from Hypertherm suggested that as well. Do you have personal experience with this problem? I did turn on the air through the hose...
I built a 5' x 10' plasma table using a Bulltear gantry kit and CandCNC BladeRunner controls back in 2012. Here is the build thread...
Drain tank
The table drain tank has slightly more capacity then the table with about 180 usable gallons. It is constructed of two pieces of 12 gage to minimize seams. The tanks seams were welded...
Mounting Accessories
The basic table structure assembly was pretty quick and painless taking less then a week since that part was fully designed. I decided to design the under table component...
Frame Assembly
All the tubing was cut out with remarkable accuracy on a 1950’s era Marvel 8 bandsaw.
229028
The three leg assemblies were assembled first. The three 3” x 5” tubing pieces were...
I am finally getting around to documenting my 5’ x 10’ Bulltear plasma table with tube cutting area build.
There is 64” x 124” sheet cutting area and a 12” trough area to one side for tube...
Dave,
I noticed you must have relocated the control panel for the CandCNC controller to the end panel. Did you have to extend the wires? Also how did you route wire through the controller box? ...
How do you like the air bladder water table? Would you change anything about the design? Is there any concern with plasma dust build up in the air chamber with no way to clean it out. Is there any...