I should have come back to this a lot earlier, years in fact ? just in case anyone else has the same issue, problem turned out to be the coolant solenoid. I installed a DRO on all axis in order to...
Type: Posts; User: Eddie UK
I should have come back to this a lot earlier, years in fact ? just in case anyone else has the same issue, problem turned out to be the coolant solenoid. I installed a DRO on all axis in order to...
Thank you, I will look into that.
Eddie
I would really appreciate some guidance from the more experienced folks on here, Im at the head scratching stage !
Problem I have is that when I do multiple small cuts, 5mm long using a centre...
We are a lot closer now? Phil kindly gave me a call yesterday & gave me a few pointers. First problem was my pulley config, I read the specs 400 rpm min & 6000 max for my motor. I set the max to 5000...
Thank you again for your replies. It never crossed my mind that this machine has a fault, everything works? I presumed that this was a calibration or settings issue. Due to my lack of experiance with...
Mike,
Yes, I bought it from Amadeal. Hugh has been good to deal with & was straight with me from the start explaining that he had little technical knowledge when it came to these machines & he has...
That's a good point Phil. I was presuming that when I try the machine in manual mode the speed is correct or very near. The specs of my motor are 400 - 6000 rpm so when I turn the dial to max I get...
Hi Mike & Igg1e,
Thank you for your prompt replies.
A spread sheet is a good idea but spending all this money I expect the thing to work out of the box, or is it me? I have emailed Syil China...
I have just taken delivery of a new X6 Plus linear and I am now on the steep learning curve using Mach3 for the first time.
I have had a few teething problems mainly down to a dodgy 25 pin socket at...