Hi,
I bought an old busellato jet 3006 and it came without a controller. Does anyone have any info
on what they used in these?
Thanks,
Thomas
Type: Posts; User: thomasfreedy
Hi,
I bought an old busellato jet 3006 and it came without a controller. Does anyone have any info
on what they used in these?
Thanks,
Thomas
Hi,
Are there any demos & post files? I just installed the latest demo and there are no files.
-Thomas
Hi Al,
Do you think a AMC BE25A20 would be a suitable match?
Thanks,
Thomas
Hello,
I'm trying to find what type of Brushless servo I have, it is a MPM11405-705 made by Custom Servo Motors. It has encoder/hall/Tachometer
would that be a AC brushless or a DC brushless?...
Hi,
Does anyone know of a modern replacement for a Servo Dynamics SDBF1422 driver?
Thanks,
Thomas
Hi,
I'm trying to setup a Ethernet Smoothstepper + C32 R5.4 breakout + MPG4, does anyone have a basic wiring schematic to start from. Trying to set this up from the
manuals on the CNC4PC site...
Here are the specs on the motor
Spindle type: GDZ-11
Speed: 60000rpm
Power: 100W
Voltage: 36v
Current: 0.6-1.5A
Frequecy: 160-1000hz
Cool: Self-cooling
Hello,
Can anyone recommend a 110V high frequency vfd? Looking for a VFD to run a chinese spindle 0.095kw 333hz -> 1000hz.
So far I can only source 220v.
Thanks,
Thomas
Hi,
I'm looking for a way to mill two slots in sched 40 aluminium pipe as per sketch. What would be an accurate way to align the pipe after the
first slot?
Thanks,
Thomas
I'll take some tomorrow, yes it is 220 single. Two of the capacitors blew so I replaced all but the large 375V 1200uf one. Do you
think that could be the issue?
-Thomas
It has been running for a while.
Hello,
I'm looking for some help with a Saftronics G3u-22P Inverter, this drive is on a Brideport and
as soon as I put a medium load on the spindle the drive faults out with a UV1 - DC bus...
Is there no way to see which tool causes the warning?
Hi,
Is there a way to find out which gcode line has caused a soft limit?
-Thomas
Received info from Kennametal. Attached in case someone else is looking.
-Thomas
Hi,
I have a Series I CNC with the Erickson QC 30. My old Locknut went bye bye. I just bought a new one and have
some setup question. How does one put this on? Do you have to remove the long...
Hi,
Does anyone know where I can find QC30-ER32 holders at a reasonable price?
Thanks,
Thomas
Hi, Im getting the battery open also, were you able to fix it
Thanks,
Thomas
Hi,
Does anyone know the best flow rates for metering valves used on a one shot oilier like on the KX3, X4 cnc mills?
Thanks,
Thomas
Hi,
Does anyone know the flow rates of the metering valves used on the KX3?
Thanks,
Thomas
Hi,
Anyone have any drawings for a chip tray like the
one shown on the new X4?
http://www.syil.com.cn/x4.asp
Thanks,
Thomas