Search:

The autolathe is made by Leadwell it’s an LTC-15 and the encoder is made by NSD Corporation

So an update we managed to find the parameter that allows you to turn off the signal from the encoder. After doing so we could change tool stations fine. We ran programme with multiple tool changes...

Managed to turn off encoder signal and machine worked for about an hour running programme and changing tools but then collided. So until solved had to go back to only running one tool station

Yep but black. It has 10 coloured wires. Think it’s 24v 50hz

What do you mean 482.5 ? There are no .5 there is 483 or 482

What do you mean diplomatic ?

Diagnostic 423 if I change first zero to one I can switch off encoder and it works but after a few hours machine selected wrong tool and collided.

[QUOTE=stevenlee;2446940]

The encoder doesn’t control the turret position the console does that the encoder only confirms its there. It has 10 wires 1 ground, 1 positive 24volt and 8 tool...

[QUOTE=stevenlee;2446940]

[QUOTE=zavateandu;2446936]What machine type and model do you have?
why you want to remove the turret encoder signals?
Tell us more information about your problem,maybe we can help for repair not...

We have a fanuc OT controller and I desperately need the parameter for turning off the turret encoder signal !!!

We have a Topper TMV 920 and on cold mornings when we power machine up the console comes up with (434 servo alarm : z axis detect err) And won’t allow us to reference machine. Most of the time if you...

Desperately need some help. We have a Leadwell auto lathe with 8 tool stations. But the encoder on the turret has failed. It has 10 wires. 1 is a ground, 1 is a 24 volt supply and the other 8 wires...

After returning from holiday I was informed the machine centre was not working.During a cycle the machine had jammed mid tool change. after repairing the problem I found it gave me 1031 t code alarm...

After our labourer cleaned our leadwell MCV-760 XL machine centre we turned it on and refereced it and it came up with error message OT 100 Spindle Alarm. (x sideways). It uses a Fanuc System 10M...

we have always transferred programmes from laptop to our two Fanuc machines and back and its been fine but since our laptop automatically updated some of the files are being sent broken up in to...

please help i have a carter aphs downstroke bending machine. during operation it just cut out like someone has pressed emergancy stop button. inside the machines electric cupboard one of the trip...

It changes tools perfectly but when atc arm returns to neautral position the tool being held in pot falls out because it hasnt been pushed up in to pot high enough . No matter the pisition of spindle...

It aligns perfect with spindle as we adjusted parameters on 510 and 737 its just the atc doesnt push up far enough to click tool in to the pot not the spindle and it falls out. We can see a clean...

we have a topper tmv920 using a fanuc o-m series controller. we recently lost all our parameters and had to employ guy to put them back in. but since he has the atc arm seems to sit 3mm too low. I...

if it helps the electrical box with position sensors above the arm say
prs-7 arm stop
prs-6 arm midole detect (i havnt spelt middle wrong its spelt like that on sensor)
prs-5 arm zrn position
...

we have a topper tmv-920 machine centre with a fanuc series o-m controller.recently we lost all the parameters and had to get a guy in to re-install them all. but since then the tool change arm...