Through hardship to the stars.
When I did not know Alphacam. It’s very difficult to study this on our own. For money, I was also trying - nothing good. But I was never afraid to seem like an...
Type: Posts; User: Alexsandr
Through hardship to the stars.
When I did not know Alphacam. It’s very difficult to study this on our own. For money, I was also trying - nothing good. But I was never afraid to seem like an...
I am new to homag machines.
For a bunch of alphacam + homag, you need to enter values into the tool in alphacam, for correct operation. Please explain why this is necessary. What's the point?
Need professional advice.
For a start, a small introduction
I have experience of working on 3 coordinate of Chinese machines under the control of a nc studio. I worked in the program Alphacam-...
I work in NC-STudio. To test the trajectories I use the program emulator NC-Studio in the home.
However, the parameters NC_Studio are relatively simplified in comparison with the possibility of...
Thank you!
Huge gratitude!!!
Thanks FrankCNC I solved the problem right away.
I have a question.
1-Is it possible to make sure that comments are not generated at first along with the program?
2- How to delete the percent...
Thank you so much!
I just had a long time without a computer and could not immediately answer
Hello, dear professionals.
How to add to the block the post responsible for changing the tool parameters:
$------------------------ TOOL CHANGES --------------------------------------
$70...
Thanks for the response. Tomorrow at work I'll test. While I solved the problem with the help of constrain and manually editing the tool path by points
Trimming angles in Alphacam.
I can not solve the problem with constrained parametric angles in Alphacam.
For the drawing, I'm using 3d polylines. To draw the path of the tool by which it will...