Cincinnati Milacron Arrow 750, A spindle motor went out. I pulled one from another machine but I cannot figure out how to get the alignment right after several attempts.
Right now on M19S0 it just...
Type: Posts; User: NationalAutomat
Cincinnati Milacron Arrow 750, A spindle motor went out. I pulled one from another machine but I cannot figure out how to get the alignment right after several attempts.
Right now on M19S0 it just...
Mike,
It wasn't the program doing it. Not sure how, but today I restarted the machine, browsed the machine settings, didn't change anything, went back to machine view and boom the run program...
Thank you.
I did the tests as described below. The motor is black and I can turn the screw by hand. The voltage from plug 33 going to the electromagnet in the brake is getting 97vac. The control transformer is...
Mike, I have done the test this morning. In all 3 scenarios I get: Z axis servo fail The z axis follwing error has exceeded the configured servo fail limit 27.999 Verify axis gains and drive...
Who is Fives?
All of this started when the roof gave way during a storm a few weeks ago. The z motor took on water because the cover had gotten lost. I did not know it had water in it when I started the machine....
I have an arrow 750 with a z axis that went into foldback on machine alignment. I replaced the servo with a used one from ebay and get the same result. The screw is not in a bind. There are no other...
Am trying to commission an Arrow 750. Have transferred an nc file into machine via serial cable. But the "run this program" button is greyed out. I can edit, save and delete but I cannot run it....