584,862 active members*
5,349 visitors online*
Register for free
Login

Search:

Type: Posts; User: alanbredbury

Search: Search took 0.00 seconds.

  1. Replies
    67
    Views
    17,299

    Re: Wireless Pendant Won't Connect

    You know what would have been better? if I had looked in the bottom of the box that the pendant came in and found the disk supplied with it. I always have to do things the hard way.
  2. Replies
    67
    Views
    17,299

    Re: Wireless Pendant Won't Connect

    Thank you very much, I don't read Chinese at all and though i was able to locate the site I couldn't find the link. You saved me much time. Works like a charm, very cool. I can't believe I went so...
  3. Re: machine hesitation at the end of each line of code

    Ok Tonight I tried to install a cheap PCI video card, the Dell wont accept it. Once again supporting my concept that the video card is integrated so tightly into the system that it hits the processor...
  4. Re: machine hesitation at the end of each line of code

    I did look at it while running, I don't remember the exact numbers, I will try to spend a few minutes tonight and get them but I would have been concerned if it was more than 60% while running, quite...
  5. Re: machine hesitation at the end of each line of code

    end of every line of g code it pauses
  6. Re: machine hesitation at the end of each line of code

    sorry Mach 3 using about 30% if I remember correctly, certainly no where near all of it
  7. Re: machine hesitation at the end of each line of code

    Thank you, I am aware of the dedicated machine requirement as I have been running Mach 3 successfully for at least 5 years.
    I did not know about potential dell problems.
  8. Re: machine hesitation at the end of each line of code

    You said
    "On the Diagnostics page there's a button by the toolpath to turn it on/off. "
    I will look for it, probably wont get a chance till tomorrow night.

    You said
    "Setting the proper CV mode...
  9. Re: machine hesitation at the end of each line of code

    You said "How many lines of g-code is it? If it's a few hundred thousand or more, than try turning off the toolpath."
    I don't know how.
    instructions on how to do this would be helpful, I don't...
  10. machine hesitation at the end of each line of code

    I have been searching the web for hours. I have a cnc router running Mach3. I have an HP pentium4 running it and it has been running fine for years. I got my hands on an old Dell cad station with a...
  11. Matsuura MC510VS with Yasnac 3000G control all axis drop out when moved too fast

    We have a Matsuura MC510VS with Yasnac 3000G control. It was working fine then we moved it wired it in the new location. Now all the axis move fine when moving slowly but as soon as you try to move...
Results 1 to 11 of 11