Looking to find a new calibration service. What calibration service do you use for your set-plugs and thread rings? Thanks for your time.
Type: Posts; User: tracystrehl
Looking to find a new calibration service. What calibration service do you use for your set-plugs and thread rings? Thanks for your time.
Thank you very much for your time. I am going to take a look.
We have a Keyence Instant Measurement machine. It is accurate to.00001. It does measure threads and pitch and pitch deviation, if you have enough length(at least 3 to 4 full threads). It does not...
Good morning. We recently aquired a few gages from auction. Some are Mitutoyo Digital indicator model #ID-F150E, code #543-554-1. I have never had a gage with range and all that and would prefer to...
:wave:It has been a long time and I have been recruited to remember setting a tool on a Sugino CNC. I touched it off, but cant remember how to call up the tool offset page.... Thanks in advance.
I am trying to make an offset on a Sugino CNC. How do I get to that page? It has been a long time... I touched off my tool, I cant seem to figure out where to go with my number.
What do the letters "G" and "H" designate in regards to a metric thread? ex: M12x1.25-6H... Is this the same as "A" and "B" (male and female?). Thank you.
Thank you. I will be researching this today.
we used a 10lb.x .004 capacity scale. The problem becomes the sampling. We run these parts from tubing that can vary in wall thickness. We have to hand count samples with each run. Sometimes we have...
Not sure where to post this.. I am looking for an efficient way to count small light weight parts. We have a scale, but it doesn't detect the small weight differences of the smaller parts. Counting...
We are tooling up to run a new job. That is the designation on the print. I have ordered nuts, but would like a little tighter baseline, like a pitch to go by. I think my pitch is .4473/.4437. They...
Thank you. This job is becoming a pain.lol
Thank you. Where did you get the H=.0451? I'm trying to figure out where I'm going wrong. I got .03067. Thanks again, this is driving me crazy. I appreciate the help.
I am trying to find specs on 15/32-32 external threads. The Handbook was of no help. I am trying to skirt special ordering thread ring gages for $600. I can not seem to find what the pitch, major or...