Search:

So I guess the Kanalog inputs for each axis encoders are more than with enough reserve , my servo motors are DC permanent magnet motors and their max RPM is 1200, maybe you can already recommend a...

Well ofcourse I am keeping the tacho feedback to the drive amplifiers, otherwise my servo motors would not work.
Yes I am keeping the original indramat drives and servo motors and they all work by...

but if i put rotary incremental encoders on the servo motors then I have no linear scales , could I just do with those rotary encoders or should I instead put linear scales?

The original servo motors have only built in tachogenerators with feedback back to the original drive amplifiers. nothing more.

I guess I have to ask then , what would you folks recommend me to do, should I use encoders on each of the servo motors and they would be good enough in accuracy or should I buy some modern linear...

so @rotarySMP you are saying that it should be better to implement new types of linear scales rather than put encoders on servo motors?

I guess the logical step to take would be to get scales that can be directly wired into the Kanalog board without any extra boards, right?
Well the limit switches have wiring and it can be separated...

is there any reference of thread where this "Mullernick" has written about these Phillips encoders and their unsuitability to the Kanalog board input?

Ok so for the limit switches I can simply take a 24v dc source connect the - or gnd to each of the opto input gnd or - terminals and take the positive output of the 24v source and route it to each of...

Well I don't know what type of reader the original Philips PE2580 is , whether differential or single ended , tried searching but can't find any luck.Maybe someone here can tell me ?
All I know for...

Hey guys, so I have this MAHO , all 3 servo drives are working as should, all motors are also working , the spindle drive and motor is also there. The MAHO has it's original glass linear scales on...

Ok , I managed to get my drives to work. Somehow I can't explain how previously they did not work even though I set every wiring up to the schematics but then as I swapped the tacho generator wires...

So I have tried to get the drive to work properly but with no luck so far.
I used pins 29 and 30 to add 0-10 volts DC via a rheostat from a 9v battery in order to control both the rpm of the motor...

Yes my drive is 1TRM3, I already have this manual in a print out version that came along with the machine , it is in german and I have studied it but I can't seem to understand exactly how to wire up...

Sadly my pinouts are different than yours. Thanks for the links to the Kflop input/output examples, my friend is already working on those but I need to sort out the drives.

So I cannot find a pin...

Hi folks,

my problem is the following, I have a MAHO cnc with these drives and the original controller/computer is dead and gone, so I need an idea to figure out how to connect these drives to a...

Hi guys,

So I got the Maho 1000c cnc , from 1988. The thing is the original computer/controller unit is gone together with the screen and button control table, the servo drives are in place and...