Search:

I'm having an Issue awhile back I found the 4 wires going to my limit switches were broken and sticking out of the wire harness that hooks on to the laser head. I replaced the 4 wires that were bad...

Does anyone know anything about limit switches and homing issues?

I'm having an Issue awhile back I found the 4 wires going to my limit switches were broken and sticking out of the wire harness that hooks on to the laser head. I replaced the 4 wires that were bad...

I'm using corel draw and corel laser and I'm having this problem can anyone help?

Jerrywu I'm having the same problem but I'l using coreldraw and corellaser what can I do this is driving me nuts

First when I bought the laser it worked fine then one day it just stopped working well I finally figured out that the switch wasn't making contact on one side so I fixed that and now it powers on ok....

I just purchased the ENGRAVER MACHINE 60W it took me all day to figure out how to get my computer to find It when I finally got it working the laser seemed weak I put it up to 90% and it wouldn't cut...

The problem is It doesn't power on at all it's dead it was running fine and the it shut off not even the the blower or water pump the nothing

if it was the tube wouldn't the whole machine at least start up it is completely dead I was making something and I thought it blew a fuse because it completely shut off but the fuse wasn't blown I...

yes that was the first thing I tried I was standing there watching it run when it happened it just was in the middle of running and it shut off like I blew a fuse in the house but it wasn't the fuse

I saw two fuses inside the unit one was soldered directly they both looked ok

Ok thanks I'll have to check out the switch where did you order the new switch from?

What was the name of the part that you looked up to find it I did searches for different switches but I didn't get any results

ok thanks mine doesn't have a key it's just a 2 position switch will that one work?

ok thanks everyone for the help I'll try getting a new switch and see if it starts up then I make sure the laser is aligned properly. Also thanks for the videos. Also I have one more question once I...