I'm not at the shop now, but I think they're these (either in the 4mm, 5mm, or 8mm variant):
https://www.cncpd.com/product/colombo-sensor-4mm/
If so I can easily interface them to my Masso G3...
Type: Posts; User: Metzenovich
I'm not at the shop now, but I think they're these (either in the 4mm, 5mm, or 8mm variant):
https://www.cncpd.com/product/colombo-sensor-4mm/
If so I can easily interface them to my Masso G3...
Thanks for that.
At least on the top diagram I have the sensors show they have indicator lights. I need to see if there is anything special about them (specific voltage needed, etc) or if they're...
I decided to try figuring it out by pressurizing the lines one by one. Here is what they do for any that come after me.
The two at the top:
Drawbar actuator (medium tube)
Cone clean (small...
I inherited a Gerber Sabre 408 and have retrofitted it (Masso G3, new closed loop Nema 34 stepper motors and drivers, etc). So far so good.
The Colombo RC110 ATC spindle has 6 air lines going into...
I'm retrofitting my Sabre 408 with the Masso G3 controller ($900 with accessories and shipping) and 12NM NEMA 34 closed loop steppers ($180 each x3), using the existing 74v power supply. To get NEMA...
I was able to get it to work by going into settings and configuring the spindle to "Router" (the other options are "Spindle" and "Spindle with ATC").
This at least lets me run g-code on the...
Thanks. I already have the spindle working from external 0v - 10v control (separate from the Gerber).
I monitored the wires that control the 3 phase spindle from the Gerber main control box and...
I have a Gerber Sabre 408 router that has a 3 phase Colombo spindle, but my residential shop only has single phase 220v power.
I've hooked up an external single phase to 3 phase VFD and I can...