I haven't tried that, I probably should have.
I was able to make it past that hurdle, though. The problem was that LinuxCNC was using the incorrect address for the parallel port. I was able to...
Type: Posts; User: Marshallj
I haven't tried that, I probably should have.
I was able to make it past that hurdle, though. The problem was that LinuxCNC was using the incorrect address for the parallel port. I was able to...
Wiring Info:
PC using a parallel card going through the parallel cable to the C10.
C10 powered by USB brick, 5V 1A. 5V goes to power and enable, GND goes to GND
C10 jumper settings:
Pin 2-9...
A few years ago I bought parts to convert a Grizzly 722 mill to CNC. I finally got around to assembling everything but I can't get it working.
Here is my setup:
C10 breakout board
Ethernet...
I picked up the machine... having trouble getting it into the basement. It's heavy as hell.
Hypnotoad, that looks like it. Thanks for that info.
I recently purchased a Grizzly G0722
and I would like to do a CNC conversion to it.
I see that there is tons of info and kits available for the G0704 but almost nothing for the G0720/G0722. In...
The guy on that site is a loon.
I've done some research on these things and it turns out that nearly all of these "amazing alternative energy" stories turn out to be bunk.
Most of the time these stories are cooked up by people...
I built one of those a while back. It worked, but it seemed very limited with what software it could use.
A lot of programs just use the step/direction commands and this wouldn't do that.
For...