Well, I'm keeping my fingers crossed, but I think I might have nailed it.
I went to hook up my computer inside the cabinet to diagnose with the program I downloaded and the #1 Y axis had an error...
Type: Posts; User: twodeuce
Well, I'm keeping my fingers crossed, but I think I might have nailed it.
I went to hook up my computer inside the cabinet to diagnose with the program I downloaded and the #1 Y axis had an error...
Looks like this might be the culprit. I rechecked all the gears and belts on the y axis. When the machine is on, the right side servo (as I'm looking at it from the front of the machine) is rock...
I will try tomorrow morning. I downloaded the software and I'll grab a mini USB.
Thank you!
Brandon
Yes, that's my Controller. I looked through that thread without anything specific to my issue really.
It runs on simple G code.
It came setup, but has never been adjusted. Hence my issue....
Wow, thank you!
I included a couple of photos that show the cuts at 120 IPM with 1/4 upcut spircal carbide bit. It gets much worse the faster I go.
The spindle is HSK (Photo attached).
X and y...
I'm in the Kansas City area.
Hi Everyone,
I run a small cabinet shop and recently purchased a 4x8 CNC router from China (you might have heard a similar tale as the one I'm about to tell before).
It has a lot of quality parts...