Did you ever get a reply?
Type: Posts; User: ozyjimbo
Did you ever get a reply?
sorry it wasn't accel it was velocity that was high
Ger i reset the steps to 2400 i did a couple of tests still had the same problem however i decided to go into my motor tuning and discovered i had accel at 4000 i reduced it to 3000 and now after 5...
i'll try that thanx ger just seems odd if i'm loosing steps then it would do it way before going over 1000mm i'll do more adjusting very soon and see what i come up with and yes i agree there should...
I have been trying to nut this little problem out i have set my machine using mach3 steps. My table size is 1200x2400, the x axis is mm perfect however my y axis is misreading, i have that set to...
Does anyone have a copy of the engrave.dll as i have tried the site mentioned but it's closed down now?
it should work with aspire make your tool path for engraving with a diamond drag bit this will allow you to set pressure of course i haven't done this so you will have to trial and error and just...
about the only problem i had was with the torch height sensor apart ftom that it was pretty easy to setup but if you are looking for a budget thc check out the mini thc i have one and it's great
...
I have the thc3t-04 and have been impressed with it so far takes a little to configure but once done works like a charm cheap yes works yes and have had plenty of support from the company
gabriel they probably wont give you the manufacturers param reset password as it might stuff up some of the parameters well thats what they said to me tomorrow i can take some screen shots of my...
what ebay seller did you get yours from i got mine through startvipstore
quickcut i have the same machine and mine is running fine you have to set the software board the same as the laser board in software go to config then system settings untick the x axis and tick the y...
i was only able to remove my e stop and turned that into my touch probe so i don't have an e stop as yet
try this go into your preferences of the laser and select the device that says 6c**** M2 then reboot computer while laser is still on see if that works for you
65 views and no suggestions? am i on the wrong site?
Hey guy's just a bit of a problem i'm having and hope someone may know the answer i'm trying to route out a square pocket i use artcam to write the g code and use mach3 it seems to be not following...
G'day John added some pics of the 3040 bob as you will see that i have marked the estop pins on my software is input pin 10
G'day John,
Couple of pics as per private message
after i installed the software i had the same problem untill i turned off the laser and back on and restarted the software again and was able to select the device