Search:

Hi, somebody could help me with the manual.

Thanks

I've bypass the E-stop but the same, if the E-stop is engaged the motor will slow down at 4500rpm and when it is reset it will speed up at maximum speed. Still i think something i miss from config,...

Thanks, at this point i don't want to use any relay, just i will bypass the Emergency E-stop.

No i don't have hardwired the E-stop, what is the control relay?

The signal is very noise, run at 25khz but noise.

I still believe the software is not set properly. Now after i've done a spindle calibration when i'm turning on it will gain speed gradually.
But...

Yes, SW3 is ON, the others are OFF.

I've checked the output and is not PWM signal.

EDIT:


I've been playing around and set the Output Signal:
Output1 to pin 16 and Output2 to Pin 17.

I've tried your settings and it work nice! thanks

Now i have a few issues:
- setting up the PWM, as i setup didn't control the speed, it measure but cannot set.
- when i close or open the...

Thanks a lot!

Tomorrow i will try.

Thanks for quick answer.
At this point i just want to test the motor/driver(just bought it). In the future i want to use PWM.
To use PWM i need to invert the signal.

Hello,

I just bought a control board DB25-1205 and a spindle motor driver DDBLDV1.0 but i have issue configuring Mach3.

The ports on control board are enable 16 and direction on 17. But i...