is the hesitation coming from the 4th axis clamping?
Type: Posts; User: budgieW
is the hesitation coming from the 4th axis clamping?
Do you have this manual?
DNC-T/DT/RT and IT Plaza Set
Just to confirm do you have DNC-B or DNC-DT as they are very different
DNC-B is drip feed only through RS232 similar to FANUC tape mode
DNC-DT has an on board data server, Basically an SSD in the...
The line of code should look something like this
G131 F10000. J2 E.03 D.01 I3 L5. R.3 K0
What does the program look like?
Lathe is V100 mill is VC100
What State are you in?
Sounds like an excellent way to crash it.
I have made plenty of splines with Mastercam's gear generator, all have passed the QC tests
Try this
VOPRB[2]=VOPRB[2] OR 128 (Sets NC Opt Para Bit No2. Bit7 to 1)
Code in here
VOPRB[2]=VOPRB[2] EOR 128 (Set NC Opt Para Bit No2. Bit7 to 0)
DO you have a post processor
what model machine?
Sounds like a Post precessor issue
You need to edit the post
What control?
Have you tried a small dwell?
This CAM turning is done with a CAM turning attachment not standard Gcode on a standard machine
Nick,
Okuma support is Australia is good, I would say better than there peers in my experience, they have local Sydney based, service and appliactions which is pretty important when moving into...
Try these
VNSRX X-axis nose radius compensation amount VNSRX[12] = 0.020
VNSRZ Z-axis nose radius compensation amount VNSRZ[12] = 0.020
MDI
S500 M03
enter
cycle start
TG is for tool managment
TL=001001 is tool 1 on a 500 offset machine if you have 96 offsets this will be TL=010101
G140
G138
G0 Y0
G136
M109
(TURNING-1C-X4.MIN)
I would Guess programming or special functions manuals, You are looking for schedule file
Not quite, Save the text as a file CALL.SDF
PSELECT HD0:ROUGH.MIN (RUN FROM HD0 DIRECTORY)
PSELECT:ROUGH.MIN;S (THIS IS FOR CONTROL RUN METHOD S)
PSELECT TCA:ROUGH.MIN (RUN FROM TCA DIRECTORY)...
MD1 is the controller memory, On a U10 control this directory will be very small. You can run the program straight from the TC directory. TC: is the server HD0; is the on board flash drive basically...
Coordinate rotation is what you are after, you will need to check the spec sheet to see if you have it
Have a NT1000 here we use M395/M396 sometimes for programs on the Sub spindle.
MCS-Diff Over usually means too much load on the spindle. Take a smaller cut or slow down the feed
I think doing this is VB would be easier
Just out of interest, what does a windows simulator offer that a windows machine does not? It may work but I think the graphics will be a problem
On a CE machine the pressue switch needs to be confirmed for the machine to run. You could put the machine in "adjust mode" and over ride the PLC input for the pressue switch, but this is not...