Search:

Yes it all worked perfect, Its either the machine was in the process of being upgraded to rigid tap and they didn't finish for whatever reason or someone yanked the 1010-4 card and replaced it.
...

[QUOTE=ballistic42;2530972]Your ATC works with no issues right? The Spindle Orient works like it should?

Yes it all works as it should

Just checked and it is set for (3) Flux Vector.



I have also checked all of the error codes, the best idea I have is that I am simply not getting the software "GO" signal that I need. Then when...

I found a 97.6 1610 board for sale
...

I havent touched the VFD but I did confirm that the wiring is there for the encoder. See pictures

I have a V94.10-3 - I think that is the issue.

Yea spoke to ITS - the only thing they could offer was to sent the 1010-4 card in for diagnose but I don't think its the card that's the issue rather...

Yes here is a picture of the board, the eeproms say rigid tap.

Makes me think I need a software update - IE the 1610-1 computer memory board has too old a software version on it. - I found these...

Here are the images for what I see on the SETP pages. - the spindle options dont show anything for rigid tap although there are other settings that mention it. - Gain and Ramp.

I have a 1400-4...

I have a 1994 Fadal 4020HT with the 88HS control.

As far as I can tell this machine left the factory with rigid tapping installed or it was installed later. It has the right puzzle pieces, wiring...

If it helps anyone in the future.

I discovered that I needed to have my cable cross pins 2 and 3 instead of 2-2 and 3-3.

No idea why this machine is this way. But I can now send files to and...

Hello everyone

I have a new to me Daewoo Lynx 200B lathe, I need some assistance in troubleshooting the RS232 Communications. The machine uses a Fanuc 21-T control.

I would like to say I have...

Hi Guys, I think I made a big mistake.

Yesterday I started out with a machine that booted but wouldn't home due to an excess error on the axis, - diagnosing lead me to think the PC-ADB-01 Axis...