I download the 9 FREE "CamBam Stick Fonts" which since they are TTF so will work in Windows. You can buy some other paid fonts too.
Type: Posts; User: reuelt
I download the 9 FREE "CamBam Stick Fonts" which since they are TTF so will work in Windows. You can buy some other paid fonts too.
1. I would use a 2A fuse.
2. It is more important that the pump cools and protects the Spindle so it should not itself blow fuse.and stop working often.
3. So I connected the output relay from...
HDD may have a bad block or worn out bearings. so if possible turn and run the HDD upside down to use top bearings, until you get the HDD replaced
Do you have a 0.1uf Capacity across the 0-10V and ACM(analogue common) and do you pass the two wires through a ferrite core?
Measure the max. Voltage from the controller and I think you are...
You are correct as long as you are NOT pre-entering (populating) tool diameter, tool length and tool wear data into the MACH3 tool table as done in machines with auto tool changer.
If you are...
Did you get it going?
I think ONLY Tool # 0 (zero) is reserved for manual entry at the DRO.
Tool #1 and above are usually added into the MACH3 the tool table or added there by a CAM program you...
Try this.
On the config | general config
At the top right hand corner set the Debounce Interval and the index debounce both to >50 (try even 5000)
You may also need to solder 3 0.1uf capactor...
Instead of removing the internet connection (physically), you can:-
1. use a fixed IP address for the CNC PC without DEFAULT GATEWAY.
In that way you can still transfer files between PCs via the...