Search:

MagicFlame,

Do you know if it is an NPN or PNP collector? My relays are set to switch Hi.
Can you show how you wired it? I have also been driving myself nuts trying to get this portion of the...

Yes I did meter out each one. And FWD remained unchanged no matter which ground reference I used, for spindle on or off from Mach. This lead me to try the second breakout board. I believe I may have...

SOLVED!

I figured it out and managed to get it calibrated within about 2.5% of set speed and actual speed. I think I can do better by applying linearization.

I will attach an excel file with my...

F044 was set to 02 forward, and it is correctly connected from X!(VFD) to Out1/FWD BreakoutBoard. Yes the breakout board sends 0v off to 10V for 24000 rpm as it turn it off and on, i verified voltage...

OK,

I have set all the parameters as suggested. The jumper was incorrectly set, that must have been my fat finger when I was checking that they were properly jumpered.
Now;
F03=400
F11=120...

Mactec54,
I read the Chineseglish manual, and most of it made sense, save for a couple very poorly worded sections. The VFD was not setup to match the spindle as indicated by the seller. So I did...

mactec54, thanks, I have tried both VFD and Vector for the spindle with no change. I had F003 at 400, as well as you suggested in another post but was trying different suggestions. I will try the...

Found the Manual, Slightly different packaging but same guts from what I can tell;
https://www.omc-stepperonline.com/download/VFD%20manual%20datasheet.pdf

Well as it turns out it seems that the Spreadsheet and Manual will not load.
So here is the settings;
Function Value Description from Manual Value Options
1 1 Control Mode 0:valid 1:invalid...

I have spent probably 100's of hours already searching reading and attempting to solve my problem.

Problem Mach3 Breakout board sends 0-10V depending on selected speed 2.5v=6000, 5v=12000,...