Need help loading Special Fixed Cycles G34 Thru G37. Long story short, lost all memory on an Okk mill with a Mitsubishi Meldas 86M control. Was able to initialize the memory, get all of the...
Type: Posts; User: Trutech
Need help loading Special Fixed Cycles G34 Thru G37. Long story short, lost all memory on an Okk mill with a Mitsubishi Meldas 86M control. Was able to initialize the memory, get all of the...
Look at the belt that goes from the spindle to the encoder. If it is loose it can cause this problem as it is hunting back and forth to hold the position.
Look at parameter 1815. If the APC bit for that axis is set to 1 but the APZ is at 0, then it needs to be referenced.
A DHCP client is an Internet host using DHCP (Dynamic Host Configuration Protocol) to obtain configuration parameters such as an IP address. This machine must have been connected to the internet and...
Sebalj, The Spindle motor is not phase-sensitive as it is being driven by the spindle drive and not just a contactor and three-phase power. If this machine has not run properly since it has been...
Does anyone have the files to flash the bios on the realtime CPU board 3-424-2442A02 ?
Does anyone have electrical schematics for a Mori SL-3 with a Fanuc 11T control that they can email to me? It would be deeply appreciated.
Thank You,
Trutech