Search:

I would think that all you do is go into your "Machining Attributes" go into the "Operations" tab then go into "automatic operations" and click on "minimize rapid distance"
That should do the trick!

Anyone know what the steps/settings are to set an M530MH controller so it's ready to receive data from a laptop to trickle feed??? The machine in an OKK KCH 500.

Thanks!!

We have an OKK KCH500 that has no floppy drive and cannot load a program over 150k into the internal memory. Can anyone tell me how to set up the OKK to accept the DNC from the stand alone computer...

Just trying to find people in MIchigan who use FeatureCam 3D.

Have not run into too many!!! :stickpoke

Scooby

Just trying to find people in Michigan who use this software, especially the 3D.
Haven't run into too many!!! :stickpoke

Scooby

Here's what I am trying to cut. Like I said even if I just pick the surfaces on the front edge at the origin and then pick the others as check surfaces the program cuts from the back forward and...

Can someone please put me out my misery!!
Using FeatureCam 3D, I’m cutting a square cube where the corners get milled out down about 2 inches, the center is left standing ( like a square boss) and...

:drowning: WE use FeatureCam for our CNC programming. Can someone tell me why every now and then the cutter path will stop and cut a perfect circle into the job (usally scrapping the piece)?? This...