See attached. Tail stock is in the same box it was shipped in. If interested, send me a private message and we can figure out a price.
Type: Posts; User: Renovo
See attached. Tail stock is in the same box it was shipped in. If interested, send me a private message and we can figure out a price.
Sure, I'll put some images up this weekend.
Yes I do. If you are interested make me an offer.
I've got one. I only used a few times and I'm willing to sell.
The ATC board was expensive $616.25 plus tax. They did have this in stock when I called.
Hi Mak, The fuse was on the daughter board, but I do not remember which one. I sold that mill, so I won't be of much help. Tormach was helpful is diagnosing the problem with me over the phone in...
I am in the process of picking up a new to me Fadal and looking to see if any Sprutcam users have been successful with the Fadal post processor or fanuc post processor on a Fadal CNC 88HS control.
...
Michael, the spindle cap on the nose of the lathe only comes off if you take out the spindle. I have attached an image of the spindle removed from the lathe. Don't try and pry off the cap.
...
Hi Michael, accessing the rear bearing sets to inspect is straightforward; the front set requires removal of the spindle from the head stock. If you haven’t replaced spindle bearings in a lathe...
I can provide some information on the bearing used in the Tormach lathe. There are two matched sets, both NSK. Front (near spindle) are 7012 and rear is 7013. These come as matched sets and are...
I'm looking for an air powered spindle for use in a vertical mill. The NSK bantam 250 has speeds from 20,000-26,0000 rpm and has a 3/4" shank. Please let me know if you have one to sell. Kit...
The issue with my ATC progressed to the point that the fuse on the DC bus for the ATC would burn out when powering up. We connected and removed power and communication to determine which would blow...
Thanks Michael, I spent a good deal of time with Tormach today and for me it turns out my ATC board has shorted out.
Hi Michael,
I have an 1100 and had the same problem with the ATC and error message. Did you ever determine the problem and solution?
Thanks in advance.
Hope this helps. FYI, the OD of my draw tube was not consistent along the entire length. There is a reduce section near the collar.
Good thought and I will follow up with them.
I received my Slant Pro lathe in Feb of this year and finally had a chance to look into the collet closer vibration last month. After carefully indicating the index ring (< .001”) the run out of the...