Yes, that is the board I have. And the board to driver connections match your list.
I did NOT have the Output Signal -> Enable1 active and set for Port #1, Pin #14. That solved it! Thank you!
Type: Posts; User: kevbro44
Yes, that is the board I have. And the board to driver connections match your list.
I did NOT have the Output Signal -> Enable1 active and set for Port #1, Pin #14. That solved it! Thank you!
John Z, thank you for the reply!
I have confirmed all four NEMA 23 motors are connected as follows: Black to A+, Green to A-, Red to B+, & Blue to B-. *Note* I'm using the provided quad colored...
Hello! Thank you for the help in advance!
I have just finished wiring my DIY 4' x 2' CNC Router and setup the Mach3 configuration for my system. I'm using this CNC Controller Kit:
...