Hey Scott,
Thanks for posting all this. It helped me fix that problem too.
Type: Posts; User: Taflin
Hey Scott,
Thanks for posting all this. It helped me fix that problem too.
It appears that R0414.2 is what is hanging up the spindle output Y1002.1.
I am trying to get the spindle on my Hardinge Cobra 42 with Fanuc 21-T running. VFD runs in manual mode. Ladder diagnosis shows the SPINDLE RUN (SPRUN) illuminated as well as the SPINDLE STOP (*SSTP)...
I am looking to put some fresh oil in the spindle head of my 1996 Kitamura Mycenter3x. The manual is not entirely clear so I want to check in with the community here. After investigating the manual I...
I have the opportunity to pick this thing up, and a spot with three phase power.
Thank you for the interest!
Job has been contracted.
Thank you for the interest!
Job has been contracted.
Please quote in a quantity of 28.
https://drive.google.com/file/d/0BwB8-KHV-UayaGhLWFowUGVRYXc/view?usp=sharing
Thank You
Brian
Please quote in a quantity of 28.
https://drive.google.com/file/d/0BwB8-KHV-UayaGhLWFowUGVRYXc/view?usp=sharing
Thank You
Brian
If you still need this I can generate a profile as well.
Please PM me if you still need these parts made. I have several questions and options for completing your project.
One of my axis is running very rough and has no torque. Swapped the stepper same issue. Any suggestions?
Please quote in a quantity of 26.
https://docs.google.com/file/d/0B2qFQsJCZJBARDlRcFlfenI2Z1k/edit?usp=sharing
The mach 3 manual is also very helpful.
Not the back the front. It wasn't deformed too much and sprung back. Belleville washers are designed to supply spring tension, they might suit the task though. The washers (2) I used are very heavy,...
Add a large heavy duty washer to where the stud comes through the front of the box.
The front of the mill can start bending in if you over tighten the stud. I added a large heavy duty washer to distribute the load closer to the box section.
I use a Rule 12v bilge pump for a boat...
Been using the same one for years.
Edit: 360 GPH is more than sufficient.
I think the F is even more accurate than the G. They unfortunately do not advertise the rated accuracy of the G. Just slightly smaller travels.
CMM programming is a ***** if you can get someone to...
That machine is a beast, I am seriously jealous you have access to such a piece of machinery.
Best of luck!
First of all that is a Leitz. And I still bet the uncertainty is worse that 1.7ect...
For example,
The rated uncertainty of the machine I use, 1.7+3L/1000 µm where L is in mm.
A machine of that size will likely have a much larger rated uncertainty.
Now calculating for the...
It is impossible to measure with certainty 0.0001 on a CMM over that size.