tools carousel is empty and like i said as soon as it begins to turn, the alarm pops up. Even in manual mode.
Type: Posts; User: RINES
tools carousel is empty and like i said as soon as it begins to turn, the alarm pops up. Even in manual mode.
The machine seems to be level. As soon as the tool carousel starts to rotate, during a tool change, it throws up a svp alarm. 2010-11 Alarm B svp check MAaxis E453E452
i notice you are using t1 and h1 but d11. is that intentional? and are you adjusting the comp in the d11 spot?
OK, once again I am trying to diagnose svp boards. okuma cadet mate osp700 mill. the alarm is 2010-11 B SVP APA CHECK MAxis E93DE93E
I believe the error is from the z axis and tool changer. the mill...
OK, once again I am trying to diagnose svp boards. okuma cadet mate osp700 mill. the alarm is 2010-11 B SVP APA CHECK MAxis E93DE93E
I believe the error is from the z axis and tool changer. the...
Ok, so, sorry the only time i pop on here is when i have a machine problem. But good help is hard to find and yall provide a wealth of free knowledge that i cant get anywhere else.
Its been almost...
It is an OSP 700. And it is the svp data check. it started as a 923 alarm, but i could turn the machine off and on a few times and eventually it would boot and run fine. the other day the 923 alarm...
Can anyone tell me how to fix alarm 937 on a okuma cadet mate 700?
right on. I just shot you and email. getting ready to test the volts. Thank you for your time and help!!!
The problem being is that the switch is 438$ and Thats a hard bill to pay if its not the problem. And yes the machine was running fine and it just started happening.
I have this alarm "3702 C X AXIS LUBE TIME OVER" on my Okuma cadet mate. Ive found the X axis pressure switch. Its getting oil to the switch, through the lines. Does this switch go bad? Or is there...
Im brand new to the forum, so i apologize if this question has been asked in the past. Im working with an Okuma cadet mate osp 700. Just put new servo boards and a battery cassette in, trying to...